 This
adapter allows you to use microEngineering Labs programming adapters and
LAB-X Experimenter Boards with the Microchip ICD and ICD2. It also
works in the opposite direction, allowing you to connect a project board
with the Microchip ICD connector to one of our programmers.To adapt a
6-pin ICD connection to a 10-pin melabs ICSP header, just plug the modular cable from the Microchip
ICD2 (not included) into the adapter
and connect the 10-pin ribbon to the ICSP header found on a programming
adapter
or LAB-X board. To adapt an melabs 10-pin connection to a 6-pin ICD port
on your project board, move the ribbon to the input side of the adapter
and use it to connect to one of our programmers. Use a 6-pin modular
cable (not included), to connect to the ICD port.
With the proper adapter, the ICD can be used to program loose
surface mount, PLCC, and DIP packages. The ICD can be used with a LAB-X
board to program a part in-circuit and step through the code for
debugging.
Use of this adapter requires a short 6-pin
modular cable that is not included. Microchip includes this cable
with their ICD2, and a 6-inch version is available
below.
Product Documentation
Sheet
|
This
USB to Serial Adapter provides a standard serial port (DB-9 male)
connection on a PC or notebook that supports USB. The serial port
can be used with the 
This 6"
cable can be used between Microchip's ICD2 and our ICD to 10-pin Adapter,
or between our ICD to 10-pin Adapter and an ICD2-compatible project board.
Use
this case to enclose and protect your melabs 
