| 3butx2.htm | PICBASIC PRO program to demonstrate multiple BUTTON
commands. Each of 3 buttons toggles an LED. Hold a button for 1
second and the LED will flicker (auto-repeat).
|
| adc10x2.htm | PICBASIC PRO program to read an analog voltage on RA0
and send the decimal representation of the value on the serial port
at 2400 baud. 10-bit conversion yields 0-1023 result for 0-5 volt input.
|
| adc8x2.htm | PICBASIC PRO program to read an analog voltage on
RA0 and send the decimal representation of the value on the serial
port at 2400 baud. 8-bit conversion yields 0-255 result for 0-5 volt
input.
|
| blink3x2.htm | PICBASIC PRO program to blink 3 LEDS in sequence.
|
| blinkx2.htm | PICBASIC PRO program to an LED connected to PORTB.0
about once a second.
|
| butx2.htm | PICBASIC PRO program to show a button press on LED.
|
| ccpx2.htm | PICBASIC PRO program to demonstrate the use of the
hardware capture module to measure the period of a frequency input.
Written for the PIC16F877 and LAB-X2 Experimenter Board.
Input signal should be connected to RC2/CCP1.
|
| countx2.htm | PICBASIC PRO program to show binary count on 3 LEDS.
|
| hellox2.htm | PICBASIC PRO program to send "Hello World" to serial port.
|
| hserx2.htm | PICBASIC PRO program to send and receive from the hardware
serial port. LEDs count characters and flash error if none received for
10 seconds.
|
| servox2.htm | PICBASIC PRO program to move RC servo using potentiometer.
|
| upperx2.htm | PICBASIC PRO program for upper case serial filter.
|
| vux2.htm | PICBASIC PRO program to display result of ADC in 3
segment bargraph. The last LED in the graph dims or brightens with
changes in the analog input.
|
| wakex2.htm | PICBASIC PRO program to demonstrate wake on interrupt.
|