| blinkxt.htm | PICBASIC PRO program to blink an LED connected
to PORTC.1 about once a second.
|
| callidxt.htm | PICBASIC PRO program to display Caller ID information
on LCD. Connect either jack on the LAB-XT to a telephone line.
Caller ID service must be provided by your local phone company.
This code only reads Multiple Data Message Format.
LED4 lights when ring is present.
|
| grabrxt.htm | PICBASIC PRO program for simple DTMF digit-grabber that
monitors for DTMF on a telephone line and displays any digits received.
Tracks display position and wraps to first position on new line.
Press RESET to clear display.
|
| hserxt.htm | PICBASIC PRO program to send and receive from
the hardware serial port.
|
| keyxt.htm | PICBASIC PRO program to display key label on LCD.
|
| phone1xt.htm | PICBASIC PRO program for simple telephone.
Press keys for on-hook, off-hook, and to dial. Incoming call
sounds ringer and flashes LED. Watches for loop-current wink
when off-hook.
|
| phone2xt.htm | PICBASIC PRO program the same as phone1xt.pbp, but
with Caller ID display.
|
| pulsext.htm | PICBASIC PRO sample program for dialing with pulses
instead of DTMF. Works as a telephone, but doesnt detect incoming
calls. See phone1xt.pbp for ring detect and ringer code.
|
| remotext.htm | PICBASIC PRO sample to demonstrate remote control using
DTMF over a phone line. The LAB-XT will answer an incoming call on the
third ring and sound a short tone to the caller. The caller can then
control 2 leds by pressing keys on his telephone.
|
| sitxt.htm | PICBASIC PRO sample Telemarketing stopper. Reads caller id
and plays Special Information Tones (SIT) when CID information has been blocked.
|
| voicext.htm | PICBASIC PRO program to record and play multiple voice messages.
Uses hardware SPI for 2-way communication to the voice device.
Record messages in sequence by pressing the A key, speaking into a headset mic,
then pressing the B key to stop recording. The first message may be played back
by pressing 0, the second by pressing 1, etc.
|